Version 05B.01.04.01
New Features:
- This new BOOT code is required for software version 05P.04.03.01 to allow for the operational code to be properly decompressed within operational memory.

Problems Fixed:

- No return to Zmodem after replacing strap.

 

Version 05B.01.03.01.03
New Features:
None.

Note that this new BOOT code may only be loaded into an Orbitor 500 that already has bullet-proofed software installed.

Problems Fixed:
- This new BOOT code is required for software version 05P.03.06.03 to allow for the operational code to be properly decompressed within operational memory.

Version BBP.05.01.02
New Features:
None.

Note that this new BOOT code may only be loaded into an Orbitor 500 that already has bullet-proofed software installed.

Problems Fixed:
- This new BOOT code is required for software version 5AP.02.06.02 to allow for the operational code to be properly decompressed within operational memory.

Version BBP.05.01.01
New Features:
-This version of BOOT code once installed provides bullet-proofing capabilities to the ZMODEM software load procedure. The bullet-proofing capabilities prevent a user from loading the wrong software into the unit.

Note that once this new BOOT code has been loaded into the Orbitor 500, any subsequent ZMODEM software loads must be in the "XXXX.all" file format. The "flash.lda" and "flash.fcs" files will not be accepted for software updates.

Problems Fixed:
- None.

Version B4C.05.00.05
New Features:
None.

Problems Fixed:
- Display correct amount of RAM for 4MB 2000s in hardware status display.

Version B4C.05.00.04
New Features:
- Universal BOOT code. This BOOT code will run on Orbitor 2000 with 1MB or 4MB of RAM and on the Orbitor 500 with 4MB of RAM.

Problems Fixed:
None.